Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER(for 4WD and Pre-Runner)
RM3250E _53 Suspension _038041 FRONT SUSPENSION _0182536 FRONT SHOCK ABSORBER(for 4WD and Pre-Runner) N

FRONT SUSPENSION  FRONT SHOCK ABSORBER(for 4WD and Pre-Runner)  DISPOSAL  


PROCEDURE

Hide 48520 1.DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY LH

HINT:

Use the same procedure for the other front shock absorber.


a.

Fully extend the shock absorber piston rod and fix the shock absorber in place at an angle in a vise or similar tool.


b.
C113162C02
1.808,0.082 2.088,0.264 0.28,0.182 10 *a
*a Approximately 45 mm


Using a drill or similar tool, slowly make a hole approximately 45 mm (1.77 in.) from the top end of the shock absorber and discharge the gas inside of it.

NOTICE:
·

The gas is colorless, odorless and harmless.

·

Since the discharged gas may cause chips to fly off, cover the drill with a cloth when making a hole.