Home › Suspension › FRONT SUSPENSION › FRONT UPPER SUSPENSION ARM(for 4WD and Pre-Runner)
RM3250E _53 Suspension _038041 FRONT SUSPENSION _0182538 FRONT UPPER SUSPENSION ARM(for 4WD and Pre-Runner) G

FRONT SUSPENSION  FRONT UPPER SUSPENSION ARM(for 4WD and Pre-Runner)  INSPECTION  


PROCEDURE

Hide 48630 1.INSPECT FRONT UPPER SUSPENSION ARM ASSEMBLY LH

C322824

a.

As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.

Turning torque:

0.98 to 4.5 N*m (10 to 45 kgf*cm, 9 to 39 in.*lbf)



c.

Check for any cracks and grease leaks on the ball joint dust cover.