Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM(for 2WD)
RM3250E _53 Suspension _038041 FRONT SUSPENSION _0182539 FRONT LOWER SUSPENSION ARM(for 2WD) G

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM(for 2WD)  INSPECTION  


PROCEDURE

Hide 48069 1.INSPECT FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH

C322836

a.

As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.

Turning torque:

0.29 to 4.5 N*m (3 to 45 kgf*cm, 3 to 39 in.*lbf)



c.

Check for any cracks and grease leaks on the ball joint dust cover.