The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front stabilizer bar removal/installation are shown below.
1.REMOVE FRONT WHEEL
51410
2.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
51442
3.REMOVE NO. 2 ENGINE UNDER COVER
51405D
4.REMOVE ENGINE UNDER BRACE SUB-ASSEMBLY
Remove the 10 bolts and 2 engine under brace sub-assemblies.
48810
5.REMOVE FRONT STABILIZER LINK ASSEMBLY LH
Remove the 2 nuts and front stabilizer link assembly LH.
If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.
48820B
6.REMOVE FRONT STABILIZER LINK ASSEMBLY RH
Use the same procedure described for the LH side.
48824
7.REMOVE FRONT STABILIZER BRACKET
Remove the 4 bolts and 2 front stabilizer brackets.
48815
8.REMOVE FRONT NO. 1 STABILIZER BAR BUSH
Remove the 2 front No. 1 stabilizer bar bushes.
48811
9.REMOVE FRONT STABILIZER BAR
Remove the front stabilizer bar from the vehicle body.