Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER(for 2WD)
RM3250E _53 Suspension _038042 REAR SUSPENSION _0182544 REAR SHOCK ABSORBER(for 2WD) A

REAR SUSPENSION  REAR SHOCK ABSORBER(for 2WD)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The RH side rear shock absorber assembly RH lower protector should face to the front side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 48540 1.TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH

C322859

a.

Install the 2 No. 1 rear shock absorber cushion washers to the axle housing.


b.

Install 4 new rear shock absorber bushes to the rear shock absorber assembly LH.


c.

Install the rear shock absorber assembly LH and 4 rear shock absorber bushes to the U bolt seat and frame.


d.

Install the 2 rear No. 2 shock absorber cushion washers.


e.

Temporarily install the 2 bolts.


Hide 3.STABILIZE SUSPENSION

a.

Lower the vehicle.


b.

Bounce the vehicle up and down several times to stabilize the suspension.


Hide 48540 4.TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH

a.

Tighten the 2 bolts.

Torque:
105 N*m (1071 kgf*cm, 77 ft.*lbf)