Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER(for 4WD and Pre-Runner)
RM3250E _53 Suspension _038042 REAR SUSPENSION _0182545 REAR SHOCK ABSORBER(for 4WD and Pre-Runner) N

REAR SUSPENSION  REAR SHOCK ABSORBER(for 4WD and Pre-Runner)  DISPOSAL  


PROCEDURE

Hide 48540 1.DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY LH

C281317C01
2.656,0.458 2.969,0.656 0.313,0.198 10 false *a
*a Approximately 40 mm


HINT:

Use the same procedure for the other rear shock absorber.


a.

Fully extend the shock absorber piston rod and fix the shock absorber in place at an angle in a vise or similar tool.


b.

Using a drill or similar tool, slowly make a hole approximately 40 mm (1.57 in.) from the top end of the shock absorber and discharge the gas inside of it.

NOTICE:
·

The gas is colorless, odorless and harmless.

·

Since the discharged gas may cause chips to fly off, cover the drill with a cloth when making a hole.