Home › Engine / Hybrid System › 1TR-FE FUEL › FUEL INJECTOR
RM3250E _51 Engine / Hybrid System _037999 1TR-FE FUEL _0182609 FUEL INJECTOR A

1TR-FE FUEL  FUEL INJECTOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the fuel injector assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
·

Replacement throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly

·

Replacement of fuel injector assembly


Inspection after repair Poor idle, engine start function, etc. (Click here)

PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 22030 4.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 23271H 5.DISCONNECT NO. 1 FUEL HOSE

a.
A353190

Disconnect the No. 1 fuel hose.

Click hereEngine / Hybrid System>1TR-FE FUEL>FUEL SYSTEM>PRECAUTION


Hide 23273H 6.DISCONNECT NO. 2 FUEL HOSE

a.
A353192

Disconnect the No. 2 fuel hose.


Hide 23270 7.REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY

Hide 23814B 8.REMOVE FUEL DELIVERY PIPE WITH FUEL INJECTOR ASSEMBLY

a.
A346778

Disconnect the 4 wire harness clamps.


b.

Disconnect the 4 fuel injector connectors.


c.

Disconnect the purge VSV connector.


d.
A346779

Remove the vacuum hose.


e.

Remove the 2 bolts and fuel delivery pipe together with the 4 fuel injector assemblies.

NOTICE:

Be careful not to drop the fuel injector assemblies when removing the fuel delivery pipe.



f.
A346780C01
0.365,0.75 0.406,0.917 0.406,0.917 0.531,0.917 true 0.542,0.813 0.75,1.021 0.208,0.208 10 true *a
*a Protective Tape


Remove the 2 No. 1 delivery pipe spacers.


g.

Remove the 4 injector vibration insulators.


h.

Using a screwdriver, remove the 4 spacers.

HINT:

Tape the screwdriver tip before use.



i.

Remove the O-ring from the spacer.


Hide 23250 9.REMOVE FUEL INJECTOR ASSEMBLY

a.
A346781C01
0,0 0,0 false
V100135

Pull Out


Remove the 4 fuel injector assemblies from the fuel delivery pipe.