Home › Drivetrain › VF2CM TRANSFER / 4WD / AWD › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM › 2015.06–2016.03
RM3250E _52 Drivetrain _038037 VF2CM TRANSFER / 4WD / AWD _0184153 TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM C

VF2CM TRANSFER / 4WD / AWD  TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0122  Lost Communication with Vehicle Dynamics Control Module  


DESCRIPTION

This DTC is output when communication is lost with the skid control ECU (brake actuator assembly) or ECM.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0100 Lost Communication with ECM / PCM "A"
·

Diagnosis Condition: Ignition switch turned to ON (3 seconds elapse after ignition switch is turned to ON)

·

Malfunction Status: Communication is lost between ECM and 4 wheel drive control ECU

·

Malfunction Time: 1.85 seconds or more

·

Other: 1 trip detection logic


CAN communication system
U0122 Lost Communication with Vehicle Dynamics Control Module
·

Diagnosis Condition: Ignition switch turned to ON (3 seconds elapse after ignition switch is turned to ON)

·

Malfunction Status: Communication is lost between skid control ECU and 4 wheel drive control ECU

·

Malfunction Time: 0.72 seconds or more

·

Other: 1 trip detection logic


CAN communication system

CAUTION / NOTICE / HINT

NOTICE:
·

w/o Multi-information Display:

When the data in the ECM or skid control ECU (brake actuator assembly) is being overwritten, the indicator light may rapidly blink due to the 4 wheel drive control ECU detecting a communication malfunction (blinks at 0.25 second intervals (0.25 seconds on and 0.25 seconds off)), but this is not a malfunction.

w/ Multi-information Display:

When the data in the ECM and skid control ECU (brake actuator assembly) is being overwritten, a message is displayed on the multi-information display and the indicator light rapidly blinks due to the 4 wheel drive control ECU detecting a communication malfunction (blinks at 0.25 second intervals (0.25 seconds on and 0.25 seconds off)), but this is not a malfunction.

·

Clear all DTCs, since DTCs are stored after the data in the ECM or skid control ECU (brake actuator assembly) is overwritten.



PROCEDURE

1.PERFORM DTC
a.

Clear the DTCs.

Click hereDrivetrain>VF2CM TRANSFER / 4WD / AWD>TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM>DTC CHECK / CLEAR

Powertrain > Four Wheel Drive > Clear DTCs
50002 363

b.

Check if the same DTCs are output.

Click hereDrivetrain>VF2CM TRANSFER / 4WD / AWD>TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM>DTC CHECK / CLEAR

Powertrain > Four Wheel Drive > Trouble Codes
50001 363

Result:
Result Proceed to
DTC is output A
DTC is not output B



A

B