This DTC is detected if communication is lost with the skid control ECU (brake actuator assembly).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0122 | Lost Communication with Vehicle Dynamics Control Module | ·
Diagnosis Condition: Ignition switch turned to ON (3 seconds elapse after ignition switch is turned to ON) ·
Malfunction Status: Communication is lost between skid control ECU and 4 wheel drive control ECU ·
Malfunction Time: 0.72 seconds or more ·
Other: 1 trip detection logic |
CAN communication system |
except Pre-Runner w/o Multi-information Display:
When the data in the skid control ECU (brake actuator assembly) is being overwritten, the 4WD indicator light and 4LO indicator light may rapidly blink due to the 4 wheel drive control ECU detecting a communication malfunction (blinks at 0.25 second intervals (0.25 seconds on and 0.25 seconds off)), but this is not a malfunction.
except Pre-Runner w/ Multi-information Display:
When the data in the skid control ECU (brake actuator assembly) is being overwritten, a message is displayed on the multi-information display and the 4LO indicator light rapidly blinks due to the 4 wheel drive control ECU detecting a communication malfunction (blinks at 0.25 second intervals (0.25 seconds on and 0.25 seconds off)), but this is not a malfunction.
for Pre-Runner:
When the data in the skid control ECU (brake actuator assembly) is being overwritten, the rear differential lock indicator light may rapidly blink due to the 4 wheel drive control ECU detecting a communication malfunction (blinks at 0.25 second intervals (0.25 seconds on and 0.25 seconds off)), but this is not a malfunction.
Clear all DTCs, since DTCs are stored after the data in the skid control ECU (brake actuator assembly) is overwritten.
Clear the DTCs.
Click hereDrivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL SYSTEM(w/ Differential Lock)>DTC CHECK / CLEAR
Check if the same DTCs are output.
Click hereDrivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL SYSTEM(w/ Differential Lock)>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output | B |
A
for LHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>HOW TO PROCEED WITH TROUBLESHOOTING
for RHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING