The ECM (engine control unit) communicates with the TCM (transmission control ECU) through the Controller Area Network (CAN).
If there is a problem with this communication, the ECM stores a DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| U0101 | Lost Communication with TCM | Both conditions are met for 1.25 seconds (1 trip detection logic):
·
The battery voltage is 10.5 V or higher. ·
No communication between the ECM and TCM. |
·
ECM ·
TCM ·
ECM to TCM circuit |
Comes on | DTC stored |
| DTC Detection Drive Pattern | Ignition switch to ON for 3 seconds |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC U0101 is output | A |
| DTC U0101 and other DTCs are output | B |
If any DTCs other than U0101 are output, troubleshoot those DTCs first.
A
B
| *a | Rear view of wire harness connector
(to TCM) |
Disconnect the TCM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G90-5 (BATT) - C77-1 (E1) | Ignition switch ON | 11 to 14 V |
Reconnect the TCM connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the TCM connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G83-22 (CAN+) - G90-21 (CAN+) | Always | Below 1 Ω |
| G83-21 (CAN-) - G90-20 (CAN-) | Always | Below 1 Ω |
| G83-22 (CAN+) or G90-21 (CAN+) - Body ground or other terminals | Always | 1 MΩ or higher |
| G83-21 (CAN-) or G90-20 (CAN-) - Body ground or other terminals | Always | 1 MΩ or higher |
Reconnect the TCM connector.
Reconnect the ECM connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the ECM.
Click hereEngine / Hybrid System>1KD-FTV ENGINE CONTROL>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC U0101 is output | B |
A
B