Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
75740
1.INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH
|
Install in this Direction |
Attach the claw to install a new rear door belt moulding assembly LH as shown in the illustration.
Remove the protective tape.
68104
2.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
67408E
3.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68152C
4.INSTALL REAR DOOR GLASS RUN LH
67842E
5.INSTALL REAR DOOR SERVICE HOLE COVER LH
67604
6.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
69284D
7.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH
8.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)
69260E
9.INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
74260
10.INSTALL REAR ARMREST ASSEMBLY LH
67674A
11.INSTALL REAR DOOR FRAME GARNISH LH
12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION