Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
75552
1.REMOVE ROOF DRIP SIDE FINISH MOULDING LH
When removing the roof drip side finish moulding LH, heat the vehicle body and roof drip side finish moulding LH using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Roof Drip Side Finish Moulding LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
for Single Cab:
|
Protective Tape |
Put protective tape around the roof drip side finish moulding LH.
Using moulding remover D, detach the clip and remove the roof drip side finish moulding LH.
When removing the roof drip side finish moulding LH, be careful not to damage the clips.
If a clip is damaged or becomes detached from the vehicle, replace it with a new one.
for Smart Cab:
|
Protective Tape |
Put protective tape around the roof drip side finish moulding LH.
Using moulding remover D, detach the clip and remove the roof drip side finish moulding LH.
When removing the roof drip side finish moulding LH, be careful not to damage the clips.
If a clip is damaged or becomes detached from the vehicle, replace it with a new one.
for Double Cab:
|
Protective Tape |
Put protective tape around the roof drip side finish moulding LH.
Using moulding remover D, detach the clip and remove the roof drip side finish moulding LH.
When removing the roof drip side finish moulding LH, be careful not to damage the clips.
If a clip is damaged or becomes detached from the vehicle, replace it with a new one.