Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
Fully open the rear door glass sub-assembly LH before proceeding with work.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67674A
3.REMOVE REAR DOOR FRAME GARNISH LH
74260
4.REMOVE REAR ARMREST ASSEMBLY LH
5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)
69260E
6.REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
69284D
7.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
67604
8.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
67842E
9.REMOVE REAR DOOR SERVICE HOLE COVER LH
68152C
10.REMOVE REAR DOOR GLASS RUN LH
67408E
11.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68104
12.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
75740
13.REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH
67872
14.REMOVE REAR DOOR WEATHERSTRIP LH
Using a clip remover, detach the clip and remove enough of the upper portion of the rear door weatherstrip LH so that the No. 2 black out tape LH can be removed.
75924C
15.REMOVE NO. 2 BLACK OUT TAPE LH
When removing the No. 2 black out tape LH, heat the rear door panel and No. 2 black out tape LH using a heat light.
| Item | Temperature |
|---|---|
| Rear Door Panel | 40 to 60°C (104 to 140°F) |
| No. 2 Black Out Tape LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Pull back an edge of the No. 2 black out tape LH and pull it parallel to the rear door panel to remove it.