Home › Vehicle Interior › HEATING / AIR CONDITIONING › HEATER SWITCH
RM3250E _58 Vehicle Interior _038073 HEATING / AIR CONDITIONING _0184575 HEATER SWITCH G

HEATING / AIR CONDITIONING  HEATER SWITCH  INSPECTION  


PROCEDURE

Hide 84453 1.INSPECT IDLE UP SWITCH

a.
E166833C01
0.052,0.073 0.365,0.229 0.313,0.156 10 false *a
*a Component without harness connected
(Idle Up Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
6 - 3 Idle up switch ON position Below 10 Ω
Idle up switch OFF position 10 kΩ or higher


If the result is not as specified, replace the idle up switch.


b.
E166833C01
0.052,0.073 0.365,0.229 0.313,0.156 10 false *a
*a Component without harness connected
(Idle Up Switch)


Check that the LED illuminates.

i.

Apply battery voltage to the heater switch assembly and check that the LED illuminates.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 5
Battery negative (-) → 4
Idle up switch illuminates


If the result is not as specified, replace the idle up switch.



Hide 87290 2.INSPECT HEATER SWITCH ASSEMBLY

a.
E323437C01
0.063,0.073 0.375,0.229 0.313,0.156 10 false *a
*a Component without harness connected
(Heater Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
4 - 5 Heater switch assembly ON position Below 10 Ω
Heater switch assembly OFF position 10 kΩ or higher


If the result is not as specified, replace the heater switch assembly.


b.
E323435C01
1.813,0.542 2.458,0.542 true 0.813,1.635 1.125,1.792 0.313,0.156 10 false *a 2.49,0.469 2.802,0.625 0.313,0.156 10 false *b
*a Component without harness connected
(Heater Switch Assembly)
*b Indicator


Check that the LED illuminates.

i.

Apply battery voltage to the heater switch assembly and check that the LED illuminates.

OK:
Measurement Condition Switch Condition Specified Condition
Battery positive (+) → 4
Battery negative (-) → 5
Heater switch assembly ON position Indicator illuminates


If the result is not as specified, replace the heater switch assembly.



c.
E323437C01
0.063,0.073 0.375,0.229 0.313,0.156 10 false *a
*a Component without harness connected
(Heater Switch Assembly)


Check that the LED illuminates.

i.

Apply battery voltage to the heater switch assembly and check that the LED illuminates.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 3
Battery negative (-) → 2
Heater switch assembly illuminates


If the result is not as specified, replace the heater switch assembly.