Home › Engine / Hybrid System › 2TR-FE ENGINE MECHANICAL › CYLINDER BLOCK
RM3250E _51 Engine / Hybrid System _038022 2TR-FE ENGINE MECHANICAL _0184671 CYLINDER BLOCK A

2TR-FE ENGINE MECHANICAL  CYLINDER BLOCK  REPAIR  


CAUTION / NOTICE / HINT

HINT:
·

Bore all 4 cylinders to fit the O/S piston outside diameter.

·

Replace all the piston rings with ones to match the O/S pistons.



PROCEDURE

Hide 1.BORE CYLINDER

a.

Prepare 4 new O/S pistons.


b.
G037359C01
3.208,1.604 3.396,1.823 0.188,0.219 10 false *a
*a Distance


Using a micrometer, measure the piston diameter at right angles to the piston center line where the distance from the piston end is as specified.

Standard piston diameter (O/S 0.50):

95.471 to 95.481 mm (3.7587 to 3.7591 in.)


Distance:

13.8 mm (0.543 in.)



c.

Calculate the amount each cylinder is to be rebored as follows.

Size to be rebored = P + C - H
P Piston diameter
C Piston oil clearance: 0.009 to 0.048 mm (0.000354 to 0.00189 in.)
H Allowance for honing: 0.02 mm (0.000787 in.) or less


d.

Bore and hone the cylinders to the calculated dimensions.

Maximum honing:

0.02 mm (0.000787 in.)


NOTICE:

Excess honing will destroy the finished roundness.



e.

Using a cylinder gauge, measure the cylinder bore diameter and calculate the honing allowance.

HINT:

Honing allowance = cylinder bore diameter - (piston diameter + oil clearance)



f.

Finish the cylinder bore using the calculated value.


g.
A348626C01
1.229,2.521 1.354,2.521 1.354,2.521 1.792,2.76 true 1.958,2.917 2.281,2.521 2.281,2.521 2.448,2.521 true 1.031,2.417 1.24,2.604 0.208,0.188 10 false *a 2.479,2.417 2.677,2.604 0.198,0.188 10 false *b 2.333,3.281 2.552,3.469 0.219,0.188 10 false *c 2.51,3.677 2.698,3.875 0.188,0.198 10 false *d 2.365,4.448 2.563,4.625 0.198,0.177 10 false *c 1.76,3.5 1.917,3.698 0.156,0.198 10 false A 1.76,3.865 1.917,4.063 0.156,0.198 10 false B 1.76,4.219 1.917,4.417 0.156,0.198 10 false C
*a Thrust Direction
*b Axial Direction
*c 10 mm (0.394 in.)
*d 70 mm (2.75 in.)
V100135

Front


Using a cylinder gauge, measure the cylinder bore diameter.

Standard oil clearance:

0.009 to 0.048 mm (0.000354 to 0.00189 in.)