Home › Engine / Hybrid System › 2TR-FE LUBRICATION › ENGINE OIL COOLER
RM3250E _51 Engine / Hybrid System _038027 2TR-FE LUBRICATION _0185054 ENGINE OIL COOLER A

2TR-FE LUBRICATION  ENGINE OIL COOLER  INSTALLATION  


PROCEDURE

Hide 15710 1.INSTALL OIL COOLER ASSEMBLY

a.

Clean the contact surfaces of the oil filter bracket sub-assembly and oil cooler assembly.


b.

Apply a light coat of engine oil to a new O-ring and install it to the oil cooler assembly.


c.

Apply a light coat of engine oil to the threads of the oil cooler union bolt.


d.
A346163C01
0.552,0.313 0.677,0.313 0.677,0.313 0.688,0.667 true 0.635,0.813 0.49,1.094 0.49,1.094 0.729,1.094 true 0.76,1.01 0.99,1.198 0.229,0.188 10 true *a 0.323,0.24 0.5,0.417 0.177,0.177 10 true *b
*a Cutout
*b Protrusion


Align the protrusion of the oil filter bracket with the cutout of the oil cooler assembly.


e.

Install the oil cooler assembly with the plate washer and oil cooler union bolt.

Torque:
43.1 N*m (439 kgf*cm, 32 ft.*lbf)


f.

Connect the No. 4 water by-pass hose and No. 5 water by-pass hose to the oil cooler assembly, and slide the 2 clamps to secure the hoses.


Hide 15601 2.INSTALL OIL FILTER SUB-ASSEMBLY