Home › Engine / Hybrid System › 2TR-FE STARTING › STARTER(for 2.0 kW Type)
RM3250E _51 Engine / Hybrid System _038028 2TR-FE STARTING _0185499 STARTER(for 2.0 kW Type) A

2TR-FE STARTING  STARTER(for 2.0 kW Type)  REASSEMBLY  


PROCEDURE

Hide 28011 1.INSTALL STARTER CLUTCH SUB-ASSEMBLY

a.

Apply high-temperature grease to the steel ball and install it to the hole of the starter clutch shaft.


b.
A343613

Apply high-temperature grease to the return spring, retainer, idle gear pinion and starter crutch sub-assembly.


c.

Install the return spring to the starter clutch sub-assembly.


d.

Install the starter clutch sub-assembly, clutch roller, retainer and starter idle gear to the starter drive housing assembly.


Hide 28150 2.INSTALL MAGNET STARTER SWITCH ASSEMBLY

a.

Install the magnet starter switch assembly to the starter drive housing assembly with the 2 screws.

Torque:
9.3 N*m (95 kgf*cm, 82 in.*lbf)


Hide 28160 3.INSTALL STARTER ARMATURE ASSEMBLY

a.

Apply high-temperature grease to the bearings and install the starter armature assembly to the starter yoke assembly.


Hide 28140 4.INSTALL STARTER BRUSH HOLDER ASSEMBLY

a.

Install the starter brush holder assembly to the starter yoke assembly.


b.

Install the 4 starter brushes to the starter brush holder assembly.

i.

Using a screwdriver, pull back the spring.


ii.

Install the starter brush to the starter brush holder assembly.

NOTICE:

Check that the positive (+) lead wires are not grounded.




c.

Install a new O-ring to the groove of the field frame.


d.

Install the commutator end frame with the 2 screws.

Torque:
3.8 N*m (39 kgf*cm, 34 in.*lbf)


Hide 28120 5.INSTALL STARTER YOKE ASSEMBLY

a.

Install a new O-ring to the groove of the starter yoke assembly.


b.
A343603C01
2.115,1.198 2.333,0.917 2.333,0.917 2.5,0.917 true 1.146,0.813 0.896,0.813 0.896,0.813 0.813,0.813 true 2.563,0.823 2.875,1.021 0.313,0.198 10 false *a 0.625,0.729 0.938,0.927 0.313,0.198 10 false *b
*a Key
*b Groove


Align the key of the starter yoke assembly with the groove of the magnet starter switch assembly.


c.

Install the 2 bolts.

Torque:
9.3 N*m (95 kgf*cm, 82 in.*lbf)


d.

Attach the wire harness clamp and connect the lead wire to terminal C with the nut.

Torque:
5.9 N*m (60 kgf*cm, 52 in.*lbf)