Home › Drivetrain › RC60 / RC61 MANUAL TRANSMISSION / TRANSAXLE › MANUAL TRANSMISSION SYSTEM
RM3250E _52 Drivetrain _038035 RC60 / RC61 MANUAL TRANSMISSION / TRANSAXLE _0185567 MANUAL TRANSMISSION SYSTEM D

RC60 / RC61 MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSMISSION SYSTEM  ROAD TEST  


ROAD TEST


a.

Check for DTCs.

Click hereDrivetrain>RC60 / RC61 MANUAL TRANSMISSION / TRANSAXLE>MANUAL TRANSMISSION SYSTEM>DTC CHECK / CLEAR

Powertrain > Engine and ECT > Trouble Codes
50001 234
HINT:

When DTCs are output, perform troubleshooting for each DTC.

Click hereDrivetrain>RC60 / RC61 MANUAL TRANSMISSION / TRANSAXLE>MANUAL TRANSMISSION SYSTEM>DIAGNOSTIC TROUBLE CODE CHART



b.

Turn the iMT switch on and off and check that the iMT indicator light illuminates and turns off.

HINT:

If the iMT indicator light does not illuminate, refer to the troubleshooting procedure for "iMT indicator light does not illuminate".

Click hereDrivetrain>RC60 / RC61 MANUAL TRANSMISSION / TRANSAXLE>MANUAL TRANSMISSION SYSTEM>PROBLEM SYMPTOMS TABLE



c.

Perform a road test.

CAUTION:

When performing the confirmation driving pattern, obey all speed limits and traffic laws.


HINT:
·

Perform this procedure with the iMT indicator light illuminated.

·

Make sure to securely depress the clutch pedal.



i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List.


v.

According to the display on the GTS, read the Data List.

Powertrain > Engine and ECT > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Engine Speed Engine speed Min.: 0 rpm
Max.: 16383 rpm
710 to 810 rpm: Idling When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 rpm or varies greatly from the actual engine speed.
Powertrain > Engine and ECT > Data List
Tester Display
Engine Speed
50003 234 9

vi.

Drive the vehicle in 3rd gear with the engine speed at 2000 rpm.


vii.

Fully depress the clutch pedal (and leave it depressed).


viii.

Immediately downshift to 2nd gear.


ix.

After the clutch is not engaged for 2 seconds, check the engine speed.

OK:

The engine speed exceeds 2500 rpm.