Home › Drivetrain › RC60F / RC61F MANUAL TRANSMISSION / TRANSAXLE › MANUAL TRANSMISSION SYSTEM
RM3250E _52 Drivetrain _038036 RC60F / RC61F MANUAL TRANSMISSION / TRANSAXLE _0185579 MANUAL TRANSMISSION SYSTEM L

RC60F / RC61F MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSMISSION SYSTEM  PRECAUTION  


EXPRESSIONS OF IGNITION SWITCH


HINT:

The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition Switch off LOCK Off (Lock)
Ignition Switch ACC ACC On (ACC)
Ignition Switch ON ON On (IG)
Engine Start START On (Start)



PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


NOTICE:

Performing iMT Installation Information Reset will clear the stored status of the iMT installation information (iMT Type). Make sure to perform iMT Installation Information Reset and set the iMT installation information (iMT Type) when replacing any of the parts shown in the following table.

Click hereDrivetrain>RC60F / RC61F MANUAL TRANSMISSION / TRANSAXLE>MANUAL TRANSMISSION SYSTEM>INITIALIZATION

Replaced Part
ECM


HINT:

Use this function to reset the iMT installation information when the sensor is wrongly assembled or the ECM is reused.



PRECAUTION


HINT:
·

The iMT system may not detect the gear change performed by the driver when a certain amount of time elapses between the clutch operation and shift operation or when the shift lever is operated while coasting with the shift lever in N.

·

After the iMT system adjusts the engine speed and a certain amount of time elapses, the operation completes. Even during this time, the iMT system operates again if it detects a clutch pedal reengagement and a gear change operation.

·

The iMT system may not operate if the clutch pedal is not completely released and fully depressed.

·

When the clutch is quickly engaged, the speed synchronization operation by the iMT system may not occur in time.

·

When there is a malfunction in the engine system or ABS system, the iMT system may stop operating.