Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY(for Single Cab) › 2015.06–2016.03
RM3250E _58 Vehicle Interior _038072 SEAT BELT _0185616 FRONT SEAT OUTER BELT ASSEMBLY(for Single Cab) A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY(for Single Cab)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedures listed below are for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:
B394719

Be sure to read Precaution thoroughly before servicing.

for Type A:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>PRECAUTION

for Type B:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 67914B 3.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 73220 4.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH (for Floor Anchor)

a.
B416216

Remove the bolt and disconnect the floor anchor of the front seat outer belt assembly LH.


Hide 73178A 5.REMOVE SEAT BELT ANCHOR COVER CAP

Hide 62512 6.REMOVE LOWER QUARTER TRIM PANEL LH

Hide 73220 7.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH

a.
B416217

Remove the bolt and disconnect the shoulder anchor of the front seat outer belt assembly LH.


b.
B416218C01
1.063,0.458 1.385,0.302 true 1.458,0.219 1.771,0.417 0.313,0.198 10 true *1
*1 Locking Button
V100155

Protective Tape


w/ Pretensioner:

i.

Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector as shown in the illustration.

HINT:

Tape the screwdriver tip before use.



ii.
B416219

Remove the 2 bolts.


iii.

Detach the 2 guides and remove the front seat outer belt assembly LH.



c.
B415715

w/o Pretensioner:

i.

Remove the 2 bolts.


ii.

Detach the 2 guides and remove the front seat outer belt assembly LH.