Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB(for 2WD)
RM3250E _52 Drivetrain _038039 AXLE AND DIFFERENTIAL _0185761 FRONT AXLE HUB(for 2WD) G

AXLE AND DIFFERENTIAL  FRONT AXLE HUB(for 2WD)  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DISCONNECT FRONT FLEXIBLE HOSE

Hide 47750 3.REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH

Hide 47722 4.REMOVE FRONT DISC BRAKE CYLINDER MOUNTING LH

Hide 6.INSPECT FRONT AXLE HUB BEARING LOOSENESS

a.
C324888

Using a dial indicator, check for looseness near the center of the front axle hub.

Maximum:

0.05 mm (0.00197 in.)


NOTICE:

Make sure that the dial indicator is set perpendicular to the measurement surface.


If the looseness is more than the maximum, replace the front axle hub sub-assembly.


Hide 7.INSPECT FRONT AXLE HUB RUNOUT

a.
C324889

Using a dial indicator, check for runout on the surface of the front axle hub inside the front axle hub bolt.

Maximum:

0.05 mm (0.00197 in.)


NOTICE:

Make sure that the dial indicator is set perpendicular to the measurement surface.


If the runout is more than the maximum, replace the front axle hub sub-assembly.


Hide 47722 9.INSTALL FRONT DISC BRAKE CYLINDER MOUNTING LH

Hide 47750 10.INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH

Hide 11.CONNECT FRONT FLEXIBLE HOSE

Hide 12.INSTALL FRONT WHEEL