Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL PLUG (for Pre-Runner)
Using SST and a hammer, install a new plug.
43502F
2.INSTALL FRONT AXLE HUB OIL SEAL LH
Using a brass bar and hammer, tap in a new front axle hub oil seal LH.
43502M
3.INSTALL FRONT AXLE HUB INNER BEARING LH (for 4WD)
Using SST and a press, press a new front axle hub inner bearing LH into the front axle hub sub-assembly LH.
Insert 4 bolts into the bearing before installing the bearing to the front axle hub sub-assembly LH.
43502M
4.INSTALL FRONT AXLE HUB INNER BEARING LH (for Pre-Runner)
Using SST and a press, press a new front axle hub inner bearing LH into the front axle hub sub-assembly LH.
Insert 4 bolts into the bearing before installing the bearing to the front axle hub sub-assembly LH.
Using SST, install a new adjusting nut.
Using SST and a hammer, stake the adjusting nut.
43502C
5.INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH (for 4WD)
Apply MP grease to a new O-ring.
Install the O-ring to the axle hub.
Install the dust cover and front axle hub sub-assembly LH to the steering knuckle LH with the 4 bolts.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a ball joint lock nut wrench (fulcrum length of 149 mm (5.866 in.)) + torque wrench (fulcrum length of 380 mm (14.961 in.)): 57.5 N*m (586 kgf*cm, 42 ft.*lbf).
43502C
6.INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH (for Pre-Runner)
Apply MP grease to a new O-ring.
Install the O-ring to the axle hub.
Install the dust cover and front axle hub sub-assembly LH to the steering knuckle LH with the 4 bolts.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a ball joint lock nut wrench (fulcrum length of 149 mm (5.866 in.)) + torque wrench (fulcrum length of 380 mm (14.961 in.)): 57.5 N*m (586 kgf*cm, 42 ft.*lbf).
43502H
7.INSTALL FRONT AXLE SHAFT NUT LH (for 4WD)
Clean the threaded parts on the drive shaft and front axle shaft nut LH using a non-residue solvent.
Install the front axle shaft nut LH.
Install the adjusting cap and a new cotter pin.
If the holes for the cotter pin are not aligned, tighten the nut an additional 60°.
43514C
8.INSTALL FRONT AXLE HUB GREASE CAP LH (for 4WD)
Install a new front axle hub grease cap LH to the front axle hub sub-assembly LH.
43512
9.INSTALL FRONT DISC
47750
10.INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH
89543
11.CONNECT FRONT SPEED SENSOR LH
12.INSTALL FRONT WHEEL
13.CHECK ABS SPEED SENSOR SIGNAL