Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB BOLT
RM3250E _52 Drivetrain _038039 AXLE AND DIFFERENTIAL _0185765 REAR AXLE HUB BOLT A

AXLE AND DIFFERENTIAL  REAR AXLE HUB BOLT  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 42403 2.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY

Hide 42312E 3.REMOVE REAR AXLE HUB BOLT LH

C325058C01
1.281,1.552 0.417,1.271 0.417,1.271 1.302,1.146 true 2.094,0.938 2.688,0.625 true 0.24,1.208 0.552,1.365 0.313,0.156 10 false *1 2.563,1.521 2.875,1.677 0.313,0.156 10 false *a 1.052,1.771 1.365,1.927 0.313,0.156 10 false *b 2.802,0.521 3.26,0.719 0.458,0.198 10 false SST
*1 Nut
*a Turn
*b Hold


a.

Temporarily install 2 nuts to the 2 rear axle hub bolts as shown in the illustration.


b.

Using SST and a brass bar or equivalent to hold the rear axle shaft, remove the rear axle hub bolt LH.

SST
09650-17011  


Hide 42312E 4.INSTALL REAR AXLE HUB BOLT LH

C325059C01
2.938,1.479 2.938,1 false 2.5,0.25 2.969,0.542 true 2.885,1.573 3.198,1.729 0.313,0.156 10 false *1 2.313,0.115 2.563,0.333 0.25,0.219 10 true *2 2.406,1.406 2.719,1.563 0.313,0.156 10 false *a 1,1.74 1.313,1.896 0.313,0.156 10 false *b
*1 Washer
*2 Nut
*a Turn
*b Hold


a.

Install a plate washer and nut to a new rear axle hub bolt LH as shown in the illustration.


b.

Using a brass bar or equivalent to hold the rear axle shaft, install the rear axle hub bolt LH by tightening the nut.


c.

Remove the 2 nuts from the 2 rear axle hub bolts.


Hide 42403 5.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY