Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Power Seat) › 2015.06–2016.03
RM3250E _58 Vehicle Interior _038071 SEAT _0185770 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:
·
B394717

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.

·

If the front seat side airbag was deployed, replace the front seat airbag assembly, separate type front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

·

Replace any other damaged parts as necessary.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedures listed below are for LHD vehicles.



PROCEDURE

Hide 1.INSTALL FRONT SEAT ASSEMBLY LH

a.
B413259

Place the front seat assembly LH in the vehicle, as shown in the illustration.

NOTICE:

Do not damage the front seat assembly LH, body exterior or interior parts.



b.
B415882

Attach the wire harness clamp.


c.

Connect the 2 connectors.


d.

w/ Side Airbag System:

Connect the front seat airbag assembly LH connector.


e.

Connect the cable to the negative (-) battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



f.

Temporarily install the front seat assembly LH with the 4 bolts.


g.

Operate the power seat switch knob LH (for Slide) to slide the front seat assembly LH to the rearmost position.


h.
B413530N01
0.885,0.958 1.104,1.198 0.219,0.24 10 true (1) 1.667,1.74 1.885,1.979 0.219,0.24 10 true (2)

Tighten the 2 bolts on the front side of front seat assembly LH in the order shown in the illustration.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


i.

Operate the power seat switch knob LH (for Slide) to slide the front seat assembly LH to the frontmost position.


j.
B413182N01
2.958,0.896 3.167,1.104 0.208,0.208 10 true (1) 1.688,1.792 1.896,2 0.208,0.208 10 true (2)

Tighten the 2 bolts on the rear side of front seat assembly LH in the order shown in the illustration.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


Hide 72138H 2.INSTALL FRONT SEAT REAR INNER TRACK COVER LH (w/ Cover)

a.
B413261C01
0,0 0,0 false
V113147

Install in this Direction (1)
V113148

Install in this Direction (2)


Push in installation direction (1) shown in the illustration to attach the guide.


b.

Push in installation direction (2) shown in the illustration to attach the claw and install the front seat rear inner track cover LH.


Hide 72138J 3.INSTALL FRONT SEAT REAR OUTER TRACK COVER LH (w/ Cover)

a.
B413262C01
0,0 0,0 false
V113147

Install in this Direction (1)
V113148

Install in this Direction (2)


Push in installation direction (1) shown in the illustration to attach the guide.


b.

Push in installation direction (2) shown in the illustration to attach the claw and install the front seat rear outer track cover LH.


c.

Operate the power seat switch knob LH (for Slide) to slide the front seat assembly LH to the center position.