Home › Vehicle Interior › SEAT › REAR SEAT ASSEMBLY(for Seat Cushion Bench Type)
RM3250E _58 Vehicle Interior _038071 SEAT _0185773 REAR SEAT ASSEMBLY(for Seat Cushion Bench Type) A

SEAT  REAR SEAT ASSEMBLY(for Seat Cushion Bench Type)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


PROCEDURE

Hide 1.REMOVE REAR SEAT ASSEMBLY

a.
B407396C01
1.396,1.5 1.813,1.083 true 1.229,1.49 1.542,1.646 0.313,0.156 10 false *1
*1 Protective Tape
V113147

Remove in this Direction


w/ Center Headrest:

Using a screwdriver, push the buckle button to release the lock and disconnect the rear seat center outer belt.

HINT:

Tape the screwdriver tip before use.



b.
B403258

Pull the No. 1 fold seat stopper band assembly to release the seat cushion lock.


c.

Fold up the rear seat cushion assembly.


d.

Attach the No. 1 fold seat stopper band assembly to the stay of the rear seat headrest assembly and temporarily fix the rear seat cushion assembly in place.


e.
B410489C02
0,0 0,0 false
V113147

Remove in this Direction


w/o Center Headrest:

Disconnect the 3 inner belt buckles from the seatback.


f.
B407397C01
0,0 0,0 false
V113147

Remove in this Direction


w/ Center Headrest:

Disconnect the 4 inner belt buckles from the seatback.


g.
B403260C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the 5 bolts.


h.

Pull in the direction shown in the illustration to detach the hook and remove the rear seat assembly.

NOTICE:
·

Removing the rear seat assembly from the vehicle must be performed by multiple people.

·

Do not damage the rear seat assembly, body exterior or vehicle interior.




Hide 71397B 2.REMOVE REAR SEATBACK HOLDER RH

NOTICE:
·

Perform the following only when replacing the rear seatback holder RH.

·

Do not reuse the rear seatback holder RH after removing it.



B407398C01
0.396,1.063 0.854,1.292 true 0.906,1.302 1.219,1.458 0.313,0.156 10 true *1
*1 Protective Tape
V113147

Remove in this Direction


a.

Using a screwdriver, detach the claw and remove the 2 rear seatback holder RH.

HINT:

Tape the screwdriver tip before use.