Wear protective gloves. Sharp areas on the parts may injure your hands.
71940A
1.REMOVE REAR SEAT HEADREST ASSEMBLY
Detach the No. 1 fold seat stopper band assembly from the stay of the rear seat headrest assembly.
Remove the 2 rear seat headrest assemblies.
71960B
2.REMOVE REAR SEAT CENTER HEADREST ASSEMBLY (w/ Center Headrest)
Remove the rear seat center headrest assembly.
71931B
3.REMOVE REAR NO. 1 SEAT HEADREST SUPPORT ASSEMBLY
|
Remove in this Direction |
w/o Center Headrest:
Detach the claw and remove the 4 rear No. 1 seat headrest support assemblies.
|
Remove in this Direction |
w/ Center Headrest:
Detach the claw and remove the 6 rear No. 1 seat headrest support assemblies.
4.REMOVE REAR SEATBACK COVER WITH PAD
Detach the hooks.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Pull out the rear end of the rear seatback cover with pad in remove in this direction (1) shown in the illustration.
Lift up in remove in this direction (2) shown in the illustration to remove the rear seatback cover with pad.
79013A
5.REMOVE NO. 1 SEATBACK COVER SUB-ASSEMBLY
Remove the 12 hog rings and No. 1 seatback cover sub-assembly from the No. 1 seatback pad.
6.REMOVE SEAT COVER WIRE
Remove the seat cover wire.
7.REMOVE REAR SEAT CUSHION COVER WITH PAD
Detach the hook.
Pull out the 2 fasteners.
Open the 2 fasteners.
Pass the No. 1 fold seat stopper band assembly through the hole of the No. 1 seat cushion cover sub-assembly.
|
Remove in this Direction |
Remove the rear seat cushion cover with pad from the No. 1 seat cushion frame sub-assembly.
79011A
8.REMOVE NO. 1 SEAT CUSHION COVER SUB-ASSEMBLY
Remove the 24 hog rings and No. 1 seat cushion cover sub-assembly from the No. 1 seat cushion pad.
9.REMOVE SEAT COVER WIRE
Remove the seat cover wire.
72995
10.REMOVE REAR SEAT CUSHION COVER RH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Pull in removal direction (1) shown in the illustration to detach the claw.
Pull in removal direction (2) shown in the illustration to detach the guide and remove the rear seat cushion cover RH.
72998B
11.REMOVE REAR SEAT CUSHION COVER LH
Use the same procedure described for the RH side.
79101
12.REMOVE NO. 1 SEAT CUSHION FRAME SUB-ASSEMBLY
Remove the 2 bolts, 2 bushes and No. 1 seat cushion frame sub-assembly together with the 2 rear seat cushion side brackets.
71223
13.REMOVE REAR SEAT CUSHION SIDE BRACKET RH
Remove the bolt and rear seat cushion side bracket RH.
71223
14.REMOVE REAR SEAT CUSHION SIDE BRACKET LH
Use the same procedure described for the RH side.
72630F
15.REMOVE REAR NO. 2 SEAT LOCK ASSEMBLY
Remove the 2 bolts and rear No. 2 seat lock assembly together with the No. 1 fold seat stopper band assembly.
78950
16.REMOVE NO. 1 FOLD SEAT STOPPER BAND ASSEMBLY
Remove the No. 1 fold seat stopper band assembly from the rear No. 2 seat lock assembly.
71485C
17.REMOVE REAR SEAT HINGE COVER RH
Perform the following only when replacing the rear seat hinge cover RH.
Do not reuse the rear seat hinge cover RH after removing it.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Pull in removal direction (1) shown in the illustration to detach the claw.
Pull in removal direction (2) shown in the illustration to detach the guide and remove the rear seat hinge cover RH.
71486C
18.REMOVE REAR SEAT HINGE COVER LH
Perform the following only when replacing the rear seat hinge cover LH.
Do not reuse the rear seat hinge cover LH after removing it.
Use the same procedure described for the RH side.