Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER MOTOR
RM3250E _59 Vehicle Exterior _038076 WIPER / WASHER _0185813 HEADLIGHT CLEANER MOTOR A

WIPER / WASHER  HEADLIGHT CLEANER MOTOR  REMOVAL  


PROCEDURE

Hide 1.DRAIN WINDSHIELD WASHER FLUID

a.
B400509C01
1.74,2.104 2,2.375 0.26,0.271 10 false 90°
V100135

Turn in this Direction


Using a screwdriver, turn the pin hold clip 90° and remove the pin hold clip.


b.
B400445C01
0,0 0,0 false
V100135

Screw
V100136

Clip
V113147

Slide in this Direction


Remove the 3 screws.


c.

Remove the 11 clips.


d.

Slide the front fender liner LH toward the rear of the vehicle and down to create a clearance as shown in the illustration.


e.
B407742C01
1.323,0.958 0.958,1.135 true 0.76,1.042 1.073,1.24 0.313,0.198 10 true *a
*a Tab
V100135

Push
V113147

Disconnect in this Direction


Push the tab to detach the claw and disconnect the headlight cleaner hose as shown in the illustration.

NOTICE:

Prepare a container before performing the procedure.



f.

Drain the washer fluid.


Hide 85280A 2.REMOVE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY

a.
B407744C01
0,0 0,0 false
V113147

Remove in this Direction


Disconnect the connector.


b.

Remove the headlight cleaner motor and pump assembly.


c.
B407746C01
0,0 0,0 false
V113147

Remove in this Direction


Loosen the clip and remove the headlight cleaner hose as shown in the illustration.