Home › Vehicle Exterior › WIPER / WASHER › WASHER LEVEL WARNING SWITCH
RM3250E _59 Vehicle Exterior _038076 WIPER / WASHER _0185815 WASHER LEVEL WARNING SWITCH G

WIPER / WASHER  WASHER LEVEL WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 85397 1.INSPECT LEVEL WARNING SWITCH ASSEMBLY

E158668C18
2.042,1.281 2.51,1.281 true 0.938,1.281 1.406,1.281 true 0.219,0.104 0.563,0.354 0.344,0.25 10 false *a 0.823,1.208 1.042,1.438 0.219,0.229 10 false E 2.552,1.208 2.813,1.438 0.26,0.229 10 false S
*a Component without harness connected
(Level Warning Switch Assembly)


HINT:

The following check should be performed with the level warning switch assembly installed to the windshield washer jar assembly.


a.

Fill the windshield washer jar assembly with washer fluid.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (S) - 2 (E) Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or more* 10 kΩ or higher
Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or less* Below 1 Ω


HINT:
·

Perform this inspection while gradually decreasing the washer fluid level.


·

*: The level warning switch assembly begins operating when the fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) depending on the vehicle condition.



If the result is not as specified, replace the level warning switch assembly.