Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR(for Steel Type Bumper)
RM3250E _59 Vehicle Exterior _038076 WIPER / WASHER _0185849 WASHER MOTOR(for Steel Type Bumper) A

WIPER / WASHER  WASHER MOTOR(for Steel Type Bumper)  INSTALLATION  


PROCEDURE

Hide 85330 1.INSTALL WINDSHIELD WASHER JAR ASSEMBLY

a.
B400412E01
2.979,0.479 3.135,0.677 0.156,0.198 10 true 1 0.948,0.333 1.104,0.531 0.156,0.198 10 true 2 0.333,3.302 0.49,3.5 0.156,0.198 10 true 3

Install the windshield washer jar assembly with the 3 bolts in the order indicated in the illustration.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


b.

Attach the clamp.


Hide 85301 2.INSTALL WASHER INLET SUB-ASSEMBLY

a.
B400411C01
0,0 0,0 false
V113147

Install in this Direction


Install the washer inlet sub-assembly to the windshield washer jar assembly.


b.

Attach the claw and guide.


Hide 85310 3.INSTALL WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.
B400409C01
0,0 0,0 false
V113147

Install in this Direction


Install the windshield washer motor and pump assembly.


b.

Connect the connector.


Hide 4.FILL UP WINDSHIELD WASHER JAR WITH WASHER FLUID

a.
B400407

Connect the washer hose.


b.

Refill the windshield washer fluid.


c.
B407712C01
0,0 0,0 false
V113147

Return in this Direction


Return the front fender liner LH to its original position as shown in the illustration.


d.

Install the 10 clips.


Hide 53892G 5.INSTALL FRONT FENDER SPLASH SHIELD FRONT SEAL LH

a.
B407710

Install the front fender splash shield front seal LH with the 5 screws.