Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR(for Steel Type Bumper)
RM3250E _59 Vehicle Exterior _038076 WIPER / WASHER _0185849 WASHER MOTOR(for Steel Type Bumper) A

WIPER / WASHER  WASHER MOTOR(for Steel Type Bumper)  REMOVAL  


PROCEDURE

Hide 53892G 1.REMOVE FRONT FENDER SPLASH SHIELD FRONT SEAL LH

a.
B407710

Remove the 5 screws and front fender splash shield front seal LH.


Hide 2.DRAIN WASHER FLUID

a.
B407711C01
0,0 0,0 false
V113147

Slide in this Direction


Remove the 10 clips.


b.

Slide the front fender liner LH toward the rear of the vehicle and down to create a clearance as shown in the illustration.


c.
B400406

Disconnect the washer hose and drain the washer fluid.

NOTICE:

Prepare a container before performing the procedure.



Hide 85310 3.REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.
B400408C01
0,0 0,0 false
V113147

Remove in this Direction


Disconnect the connector.


b.

Pull as shown in the illustration to remove the windshield washer motor and pump assembly.


Hide 85301 4.REMOVE WASHER INLET SUB-ASSEMBLY

a.
B400410C01
0,0 0,0 false
V113147

Remove in this Direction


Detach the claw and guide and remove the washer inlet sub-assembly.


Hide 85330 5.REMOVE WINDSHIELD WASHER JAR ASSEMBLY

a.
B400412

Detach the clamp.


b.

Remove the 3 bolts and windshield washer jar assembly.