Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
89543
2.REMOVE FRONT SPEED SENSOR LH
Disconnect the connector and detach the clamp.
Detach the 2 clamps.
Detach the clamp.
Remove the bolt and harness clamp.
Remove the bolt and harness clamp from the front absorber bracket.
Remove the bolt and harness clamp from the front lower arm bracket.
Remove the bolt and harness clamp.
Remove the bolt and front speed sensor LH.
Keep the sensor tip and sensor installation hole free from foreign matter.