Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › DECELERATION SENSOR(for 4WD and Pre-Runner without VSC)
RM3250E _54 Brake _038044 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0186160 DECELERATION SENSOR(for 4WD and Pre-Runner without VSC) G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  DECELERATION SENSOR(for 4WD and Pre-Runner without VSC)  INSPECTION  


PROCEDURE

Hide 89441A 1.INSPECT DECELERATION SENSOR

a.

Connect 3 dry cell batteries of 1.5 V in series (approximately 4.5 V in total).


b.

Connect the batteries' positive (+) lead to terminal 3 (VGS) and the negative (-) lead to terminal 2 (GGND).

NOTICE:

Do not apply 6 V or more to terminals 3 (VGS) and 2 (GGND).



c.

Connect the voltmeter's positive (+) lead to the negative (-) lead of the batteries, and the negative (-) lead to terminal 1 (GL1).


d.
C108887C03
2.125,0.938 1.354,0.667 true 2.344,0.938 2.375,0.406 2.375,0.406 2.208,0.406 true 2.531,0.958 2.698,0.208 true 1.74,0.281 1.906,0.479 0.167,0.198 10 false 2 2.74,0.083 3.177,0.25 0.438,0.167 10 false 1 1.198,0.563 1.385,0.74 0.188,0.177 10 false 3 2.448,2.406 2.688,2.656 0.24,0.25 10 false *a 2.24,3.313 2.49,3.531 0.25,0.219 10 false *b 1.167,4.167 1.448,4.438 0.281,0.271 10 false *c 2.75,0.24 3.25,0.417 0.5,0.177 10 false (GL1) 1.771,0.427 2.688,0.625 0.917,0.198 10 false (GGND) 1.146,0.719 1.917,0.917 0.771,0.198 10 false (VGS)
*a Front
*b Forward
*c Rearward


Check the output voltage of terminal 1 (GL1) when the sensor is tilted forward and rearward.

Standard Voltage:
Tester Connection Condition Specified Condition
1 (GL1) - Battery negative (-) lead Sensor is horizontal Approx. 2.25 V
1 (GL1) - Battery negative (-) lead Sensor is tilted forward Approx. 0.45 to 2.25 V
1 (GL1) - Battery negative (-) lead Sensor is tilted rearward Approx. 2.25 to 4.05 V


If the result is not as specified, replace the deceleration sensor.

HINT:
·

If the voltage drops, the sensor should be replaced with a new one.

·

When replacing the sensor, it should not be placed upside down.




Hide 89441A 2.CHECK DECELERATION SENSOR

a.

Check the deceleration sensor.

Under any of the following conditions, replace the sensor with a new one.

·

The surface of the sensor is cracked, dented or chipped.

·

The connector is scratched, cracked or damaged.

·

The sensor has been dropped.