Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH
RM3250E _59 Vehicle Exterior _038067 LIGHTING (EXT) _0186329 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 83910G 1.INSPECT CLOCK ASSEMBLY (Hazard Warning Switch)

a.

Inspect the clock assembly (hazard warning switch).

i.
C220881C07
1.552,0.344 1.865,0.563 0.313,0.219 1.708,1.021 0.948,0.583 true 2.688,0.729 2.042,1.042 false 0.073,0.094 0.385,0.25 0.313,0.156 10 false *a 0.708,0.479 1.021,0.677 0.313,0.198 10 false TB 2.74,0.635 2.896,0.833 0.156,0.198 10 false E 1.625,0.375 1.938,0.573 0.313,0.198 10 false H3
*a Component without harness connected
Clock Assembly (Hazard Warning Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
H3-3 (TB) - H3-1 (E) Hazard warning switch off 10 kΩ or higher
Hazard warning switch on Below 1 Ω


If the result is not as specified, replace the clock assembly (hazard warning switch).



b.
C220881C08
1.552,0.344 1.865,0.563 0.313,0.219 1.531,1.375 1.219,1.844 true 2.417,1.74 2.042,1.365 false 0.073,0.094 0.385,0.25 0.313,0.156 10 false *a 1.083,1.885 1.531,2.104 0.448,0.219 10 false ILL+ 2.365,1.792 2.688,2.042 0.323,0.25 10 false ILL- 1.625,0.375 1.938,0.573 0.313,0.198 10 false H3
*a Component without harness connected
Clock Assembly (Hazard Warning Switch)


Check the illumination.

i.

Apply battery voltage to the connector and check the illumination conditions.

OK:
Measurement Condition Specified Condition
Battery positive (+) → H3-9 (ILL+)
Battery negative (-) → H3-6 (ILL-)
Illuminates


If the result is not as specified, replace the clock assembly (hazard warning switch).