Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH
RM3250E _59 Vehicle Exterior _038067 LIGHTING (EXT) _0186331 STOP LIGHT SWITCH A

LIGHTING (EXT)  STOP LIGHT SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 84345 1.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

a.
E320316

Attach the claw to install a new stop light switch mounting adjuster.


Hide 84340 2.INSTALL STOP LIGHT SWITCH ASSEMBLY

a.
E167768

Insert the stop light switch assembly into the stop light switch mounting adjuster until the switch body slightly touches the brake pedal.

NOTICE:

Do not depress the brake pedal.



b.
E320317C01
3.135,1.573 3.333,1.781 0.198,0.208 10 false *a
*a Protrusion Amount Measurement Area


Rotate the stop light switch assembly clockwise by approximately one fourth of a rotation.


c.

Check the protrusion amount of the shaft.

Standard:

0.5 to 2.6 mm (0.0197 to 0.1024 in.)



d.

Connect the connector.


Hide 55606 3.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY