Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR
RM3250E _59 Vehicle Exterior _038067 LIGHTING (EXT) _0186333 HEIGHT CONTROL SENSOR G

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  INSPECTION  


PROCEDURE

Hide 89408C 1.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

a.

Check the rear height control sensor sub-assembly LH.

i.

Connect 3 dry batteries of 1.5 V in series.


ii.

Connect the positive (+) end of the batteries to terminal 3 (SHB) of the rear height control sensor sub-assembly LH and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR) and terminal 1 (SHG).

NOTICE:
·

Do not use rechargeable batteries as they may not output a voltage of 1.5 V.

·

Do not apply a voltage of more than 6 V.



E316976C01
5.781,1.042 6.115,1.323 0.333,0.281 6.604,2.688 6.281,2.104 true 6.271,3.073 5.906,2.125 true 5.375,2.74 5.656,2.115 true 3.594,0.313 3.906,0.51 0.313,0.198 10 false *b 3.74,0.438 4.052,0.635 0.313,0.198 10 false *c 4.313,1.104 4.625,1.302 0.313,0.198 10 false *d 4.667,2.448 4.979,2.646 0.313,0.198 10 false *e 5.229,0.938 5.542,1.135 0.313,0.198 10 false *a 3.75,0.896 4.063,1.094 0.313,0.198 10 false *f 4.25,1.813 4.563,2.01 0.313,0.198 10 false *g 6.115,3.135 6.729,3.333 0.615,0.198 10 false SHRR 5.219,2.792 5.833,2.99 0.615,0.198 10 false SHB 6.51,2.75 6.927,2.969 0.417,0.219 10 false SHG 5.854,1.094 6.125,1.292 0.271,0.198 10 false O7
*a Component without harness connected
(Rear Height Control Sensor Sub-assembly LH)
*b Vehicle Height is Low (Full Bound)
*c Vehicle Standard Position *d Sensor Standard Position
*e Vehicle Height is High (Full Rebound) *f +22.09°
*g -30.18° - -



iii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
O7-1 (SHG) - O7-2 (SHRR) +22.09° (Vehicle Height is Low) Approx. 1.7 V
0° (Sensor Standard position) Approx. 2.25 V
-30.18° (Vehicle Height is High) Approx. 3.8 V


If the result is not as specified, replace the rear height control sensor sub-assembly LH.