The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the rear height control sensor sub-assembly installation/removal are shown below.
48923A
1.REMOVE HEIGHT CONTROL LINK COVER
Remove the 2 bolts and height control link cover.
89408C
2.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
Disconnect the connector.
Remove the 3 bolts and rear height control sensor sub-assembly LH.
Detach the wire harness clamp.
If the rear height control sensor sub-assembly LH has been dropped, replace it with a new one.