Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for LHD vehicles.
84052
1.INSTALL UNLOCK WARNING SWITCH ASSEMBLY
|
Install in this Direction |
Attach the claw to install the unlock warning switch assembly to the upper steering column with switch bracket assembly.
Move the unlock warning switch assembly in the direction indicated by the arrow in the illustration to install it.
Connect the connector.
69057A
2.INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY
89782
3.INSTALL TRANSPONDER KEY COIL (w/ Engine Immobiliser System)
45286B
4.INSTALL UPPER STEERING COLUMN COVER
45287
5.INSTALL LOWER STEERING COLUMN COVER
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION