Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK(for Smart Cab)
RM3250E _58 Vehicle Interior _038064 DOOR LOCK _0186385 REAR DOOR LOCK(for Smart Cab) G

DOOR LOCK  REAR DOOR LOCK(for Smart Cab)  INSPECTION  


PROCEDURE

Hide 69360L 1.INSPECT UPPER ACCESS PANEL LOCK ASSEMBLY LH

a.
B405492C02
0.573,0.302 0.885,0.5 0.313,0.198 10 false *a
*a Component without harness connected
(Upper Access Panel Lock Assembly LH)


Check the operation of the door unlock detection switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Open Below 1 Ω
1 - 2 Half Latch Below 1 Ω
1 - 2 Full Latch 10 kΩ or higher


If the result is not as specified, replace the upper access panel lock assembly LH.



Hide 69350L 2.INSPECT UPPER ACCESS PANEL LOCK ASSEMBLY RH

a.
B405492C01
0.5,0.208 0.813,0.406 0.313,0.198 10 false *a
*a Component without harness connected
(Upper Access Panel Lock Assembly RH)


Check the operation of the door unlock detection switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Open Below 1 Ω
1 - 2 Half Latch Below 1 Ω
1 - 2 Full Latch 10 kΩ or higher


If the result is not as specified, replace the upper access panel lock assembly RH.



Hide 69390D 3.INSPECT LOWER ACCESS PANEL LOCK ASSEMBLY LH

a.
B405493C02
0.594,0.354 0.906,0.552 0.313,0.198 10 false *a
*a Component without harness connected
(Lower Access Panel Lock Assembly LH)


Check the operation of the door unlock detection switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Open Below 1 Ω
1 - 2 Half Latch Below 1 Ω
1 - 2 Full Latch 10 kΩ or higher


If the result is not as specified, replace the lower access panel lock assembly LH.



Hide 69380D 4.INSPECT LOWER ACCESS PANEL LOCK ASSEMBLY RH

a.
B405493C01
0.667,0.26 1.063,0.51 0.396,0.25 10 false *a
*a Component without harness connected
(Lower Access Panel Lock Assembly RH)


Check the operation of the door unlock detection switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Open Below 1 Ω
1 - 2 Half Latch Below 1 Ω
1 - 2 Full Latch 10 kΩ or higher


If the result is not as specified, replace the lower access panel lock assembly RH.