Home › Vehicle Interior › HEATING / AIR CONDITIONING › BLOWER UNIT › 2015.06–2016.08
RM3250E _58 Vehicle Interior _038073 HEATING / AIR CONDITIONING _0187275 BLOWER UNIT A

HEATING / AIR CONDITIONING  BLOWER UNIT  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 87165C 1.REMOVE BLOWER MOTOR CONTROL (for Automatic Air Conditioning System)

a.
E323928

w/ Rear Resistor Duct:

i.

Detach the clamp.


ii.

Disconnect the connector.


iii.

Remove the 2 screws and blower motor control.



b.
E323926

w/o Rear Resistor Duct:

Remove the 2 screws and blower motor control.


Hide 87138C 2.REMOVE BLOWER RESISTOR (for Manual Air Conditioning System, Manual Cooler System)

a.
E320394

Remove the 2 screws and blower resistor.


Hide 88548B 3.REMOVE AIR FILTER CASE

a.
E320395C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


for Automatic Air Conditioning System:

Detach the claw and guide and remove the air filter case.


b.
E320396C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


for Manual Air Conditioning System, Manual Cooler System:

Detach the claw and guide and remove the air filter case.


Hide 87139D 4.REMOVE AIR REFINER ELEMENT

a.
E320397C01
0,0 0,0 false
V113147

Remove in this Direction


for Automatic Air Conditioning System:

Remove the air refiner element.


b.
E320398C01
0,0 0,0 false
V113147

Remove in this Direction


for Manual Air Conditioning System, Manual Cooler System:

Remove the air refiner element.


Hide 87103B 5.REMOVE BLOWER WITH FAN MOTOR SUB-ASSEMBLY

a.
E320399

for Automatic Air Conditioning System:

Remove the 3 screws and blower with fan motor sub-assembly.


b.
E320400

for Manual Air Conditioning System, Manual Cooler System:

Remove the 3 screws and blower with fan motor sub-assembly.


Hide 87130K 6.REMOVE NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)

a.
E320401

Remove the 2 screws and No. 1 blower damper servo sub-assembly.


Hide 55908A 7.REMOVE AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System, Manual Cooler System)

a.
E320402

Detach the claw and remove the air inlet damper control cable sub-assembly.