27415
1.INSPECT GENERATOR PULLEY WITH CLUTCH
|
Free |
|
Lock |
Hold the center of the generator pulley with clutch, and confirm that the outer ring turns counterclockwise and does not turn clockwise.
If the result is not as specified, replace the generator pulley with clutch.
27370
2.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY
| *a | Length |
Using a vernier caliper, measure the brush length.
9.5 to 11.5 mm (0.374 to 0.453 in.)
4.5 mm (0.177 in.)
If the length is less than the minimum, replace the generator brush holder assembly.
27330
3.INSPECT GENERATOR ROTOR ASSEMBLY
Inspect that the generator rotor bearing is not rough or worn.
If necessary, replace the generator rotor assembly.
| *a | Slip Ring |
Check the generator rotor assembly for an open circuit.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Slip ring - Slip ring | 20°C (68°F) | 1.85 to 2.25 Ω |
If the result is not as specified, replace the generator rotor assembly.
| *a | Rotor Core |
| *b | Slip Ring |
Check if the generator rotor assembly is grounded.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Rotor core - Slip ring | Always | 10 kΩ or higher |
If the result is not as specified, replace the generator rotor assembly.
Using a vernier caliper, measure each slip ring diameter.
14.2 to 14.8 mm (0.559 to 0.583 in.)
14.0 mm (0.551 in.)
If either diameter is less than the minimum, replace the generator rotor assembly.