Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › IGNITION COIL AND SPARK PLUG
RM3250E _51 Engine / Hybrid System _038021 2TR-FE ENGINE CONTROL _0187727 IGNITION COIL AND SPARK PLUG A

2TR-FE ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the ignition coil assembly or spark plug removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
·

Replacement of spark plug

·

Replacement of ignition coil assembly


Inspection After Repair Poor idle, engine start, etc. (Click here)

PROCEDURE

Hide 19500 1.REMOVE IGNITION COIL ASSEMBLY

A345926

a.

Disconnect the 4 ignition coil connectors.


b.

Remove the 4 bolts and pull out the 4 ignition coil assemblies.


Hide 19100P 2.REMOVE SPARK PLUG

a.

Using a 16 mm spark plug wrench, remove the 4 spark plugs.