89467B
1.INSTALL AIR FUEL RATIO SENSOR
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.
Click hereEngine / Hybrid System>2TR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION
| *a | Fulcrum Length |
Using SST, install the air fuel ratio sensor.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 39.4 N*m (402 kgf*cm, 29 ft.*lbf)
Attach the 3 wire harness clamps to the vehicle body.
Connect the air fuel ratio sensor connector.
2.INSPECT FOR EXHAUST GAS LEAK
53882K
3.INSTALL FRONT FENDER SEAL RH