89467B
1.INSTALL AIR FUEL RATIO SENSOR
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.
Click hereEngine / Hybrid System>1GD-FTV ENGINE CONTROL>ECD SYSTEM>INITIALIZATION
w/ DPF:
Click hereEngine / Hybrid System>1GD-FTV ENGINE CONTROL>ECD SYSTEM(w/ DPF)>INITIALIZATION
| *a | Torque Wrench Fulcrum Length |
Using SST, install the air fuel ratio sensor.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 37.7 N*m (384 kgf*cm, 28 ft.*lbf)
Connect the connector and clamp.
2.INSPECT FOR EXHAUST GAS LEAK
53882F
3.INSTALL FRONT FENDER SEAL RH
for 2WD:
Install the front fender seal RH with 5 new clips.
for 4WD and Pre-Runner:
Install the front fender seal RH with 6 new clips.