Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM › 2015.06–2016.03
RM3250E _59 Vehicle Exterior _038067 LIGHTING (EXT) _0188980 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM Y

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the automatic headlight beam level control system.


·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
Result:
Proceed to
NEXT



NEXT

3.INSPECT BATTERY VOLTAGE
3.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage.

Standard voltage:

11 to 14 V



If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

Result:
Proceed to
NEXT



NEXT

4.CHECK VEHICLE TYPE
4.CHECK VEHICLE TYPE
a.

Check the vehicle type.


Result:
Result Proceed to
w/ VSC A
w/o VSC B



A

5.CHECK VEHICLE STABILITY CONTROL SYSTEM*

B

13.CHECK ANTI-LOCK BRAKE SYSTEM
5.CHECK VEHICLE STABILITY CONTROL SYSTEM*
a.

Use the GTS to check if the vehicle stability control system is functioning normally.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
Vehicle stability control system DTCs are not output A
Vehicle stability control system DTCs are output B



A

6.CHECK CAN COMMUNICATION SYSTEM

B

6.CHECK CAN COMMUNICATION SYSTEM
a.

Using the GTS to check if the CAN communication system is functioning normally.

for LHD:

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSIS SYSTEM

for RHD:

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>DIAGNOSIS SYSTEM


Result:
Result Proceed to
CAN communication system DTCs are not output A
CAN communication system DTCs are output (for LHD) B
CAN communication system DTCs are output (for RHD) C



A

7.CHECK LIGHTING SYSTEM

B

C

7.CHECK LIGHTING SYSTEM
a.

Use the GTS to check if the lighting system is functioning normally.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR

Body Electrical > HL AutoLeveling > Trouble Codes
50001 361

Result:
Result Proceed to
Lighting system DTCs are not output A
Lighting system DTCs are output B



A

8.CHECK FOR DTC*

B

8.CHECK FOR DTC*
a.

Check for DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR

Body Electrical > HL AutoLeveling > Trouble Codes
50001 361

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

9.PROBLEM SYMPTOMS TABLE

B

9.PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B



A

10.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

10.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

11.ADJUST, REPAIR OR REPLACE
11.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

12.CONFIRMATION TEST
12.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END

13.CHECK ANTI-LOCK BRAKE SYSTEM
a.

Use the GTS to check if the anti-lock brake system is functioning normally.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
Anti-lock brake system DTCs are not output A
Anti-lock brake system DTCs are output B



A

6.CHECK CAN COMMUNICATION SYSTEM

B