Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat) › 2015.06–2016.03
RM3250E _58 Vehicle Interior _038070 SUPPLEMENTAL RESTRAINT SYSTEMS _0189247 FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat) A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:
·
B394717

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.

·

If the front seat side airbag was deployed, replace the front seat airbag assembly, separate type front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

·

Replace any other damaged parts as necessary.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 73920A 1.INSTALL FRONT SEAT AIRBAG ASSEMBLY LH

a.

Install the front seat airbag assembly LH with 2 new nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)

NOTICE:
·

The nuts must not be reused.

·

Make sure that the separate type front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.



B404124C01
0.313,0.042 0.625,0.198 0.313,0.156 10 false *A 3.823,0.042 4.135,0.198 0.313,0.156 10 false *B
*A for Low-back Seat Type *B for Hi-back Seat Type



b.

Attach the wire harness clamp.

B404122C01
0.625,0.063 0.938,0.219 0.313,0.156 10 false *A 4.073,0.063 4.385,0.219 0.313,0.156 10 false *B
*A for Low-back Seat Type *B for Hi-back Seat Type


NOTICE:

Be careful not to damage the airbag wire harness.



Hide 2.INSTALL SEATBACK COVER WITH PAD

Hide 71931 3.INSTALL FRONT SEAT HEADREST SUPPORT (for Low-back Seat Type)

Hide 71759C 4.INSTALL FRONT NO. 1 SEATBACK HOOK (w/ Seatback Hook)

Hide 5.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY LH

Hide 71862 6.INSTALL FRONT SEAT INNER CUSHION SHIELD LH

Hide 71812D 7.INSTALL FRONT SEAT CUSHION SHIELD LH

Hide 72495 8.INSTALL VERTICAL ADJUSTING HANDLE LH (w/ Vertical Adjuster)

Hide 72526E 9.INSTALL RECLINING ADJUSTER RELEASE HANDLE LH

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION