Home › Drivetrain › AC60E AUTOMATIC TRANSMISSION / TRANSAXLE › PATTERN SELECT SWITCH
RM3250E _52 Drivetrain _038030 AC60E AUTOMATIC TRANSMISSION / TRANSAXLE _0189297 PATTERN SELECT SWITCH G

AC60E AUTOMATIC TRANSMISSION / TRANSAXLE  PATTERN SELECT SWITCH  INSPECTION  


PROCEDURE

Hide 84970 1.INSPECT COMBINATION SWITCH ASSEMBLY (PATTERN SELECT SWITCH ASSEMBLY)

a.
C324163C06
1.604,1.729 1.792,1.729 1.792,1.729 1.958,1.292 true 2.49,1.729 2.323,1.729 2.323,1.729 2.146,1.281 true 1.615,1.125 1.365,0.49 1.365,0.49 1.208,0.49 true 2.375,1.208 2.833,1.208 true 0.135,0.083 0.448,0.281 0.313,0.198 10 false *a 1.021,1.635 1.708,1.875 0.688,0.24 10 false 3 (PWR) 2.552,1.646 3.021,1.854 0.469,0.208 10 false 2 (E) 2.885,1.104 3.406,1.333 0.521,0.229 10 false 1 (ILL-) 0.677,0.417 1.313,0.646 0.635,0.229 10 false 5 (ILL+)
*a Component without harness connected
(Combination Switch Assembly (Pattern Select Switch Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (PWR) - 2 (E) Combination switch (PWR) pushed Below 1 Ω
Combination switch (PWR) not pushed 10 kΩ or higher


If the result is not as specified, replace the combination switch assembly (pattern select switch assembly).


b.

Apply battery voltage between the terminals of the pattern select switch assembly, and check the illumination condition of the combination switch assembly (pattern select switch assembly).

OK:
Measurement Condition Specified Condition
Battery positive (+) → 5 (ILL+) Battery negative (-) → 1 (ILL-) Illuminates


If the result is not as specified, replace the combination switch assembly (pattern select switch).