Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
84233
1.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
| *a | Component without harness connected
(Front Door Courtesy Light Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| Terminal 1 - Switch body | Pushed | 5 MΩ or higher |
| Not pushed | Below 20 Ω |
If the result is not as specified, replace the front door courtesy light switch assembly.