| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0606 | ECM / PCM Processor | ECM internal error continues for 1 second (1 trip detection logic). | ECM | Comes on | DTC stored |
| P060A | Internal Control Module Monitoring Processor Performance | ECM internal error continues for 1 second (1 trip detection logic). | ECM | Comes on | DTC stored |
| P060B | Internal Control Module A/D Processing Performance | ECM internal error continues for 1 second (1 trip detection logic). | ECM | Comes on | DTC stored |
| P060D | Internal Control Module Accelerator Pedal Position Performance | Either of the following conditions is met (1 trip detection logic):
·
There is an ECM main CPU error. ·
There is an ECM sub CPU error. |
ECM | Comes on | DTC stored |
| P1607 | Cruise Control Input Processor | ECM internal error continues for 1 second (1 trip detection logic). | ECM | Comes on | DTC stored |
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P0606 | Ignition switch ON for 1 second or more |
| P060A | |
| P060B | |
| P060D | |
| P1607 |
After replacing the ECM, the new ECM needs registration (Click here Engine / Hybrid System>2GD-FTV ENGINE CONTROL>ECD SYSTEM>REGISTRATION) and initialization (Click here Engine / Hybrid System>2GD-FTV ENGINE CONTROL>ECD SYSTEM>INITIALIZATION).
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs.
Turn the ignition switch off for 30 seconds or more.
Turn the ignition switch to ON for 1 second.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P0606, P060A, P060B, P060D and/or P1607 is output | A |
| No DTC is output | B |
A
B
Replace the ECM.
Click hereEngine / Hybrid System>2GD-FTV ENGINE CONTROL>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Clear the DTCs.
Turn the ignition switch off for 30 seconds or more.
Turn the ignition switch to ON for 1 second.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Confirm that the DTC is not output again.
| Proceed to |
|---|
| NEXT |
NEXT