Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP(for 1KD-FTV, 2KD-FTV)
RM3250E _54 Brake _038045 BRAKE SYSTEM (OTHER) _0189592 VACUUM PUMP(for 1KD-FTV, 2KD-FTV) G

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 1KD-FTV, 2KD-FTV)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 29300 1.CHECK VACUUM PUMP ASSEMBLY

a.

Disconnect the vacuum hose from the vacuum pump assembly.


b.
C111341C04
2.573,0.375 2.979,0.375 2.979,0.375 2.979,0.698 false 3,1.854 3,2 3,2 2,2 false 2.906,0.74 3.125,0.979 0.219,0.24 10 false *1 1.823,1.917 2.083,2.177 0.26,0.26 10 false *2
*1 Vacuum Gauge
*2 Plug


Connect the hose of a vacuum gauge to the vacuum pump assembly.


c.

Insert a plug into the other hose of the vacuum gauge.


d.

Start the engine and warm it up for more than 2 minutes.


e.

With the engine idling, check the negative pressure of the vacuum pump assembly.

Standard negative pressure:

More than 87 kPa (650 mmHg, 25.6 in.Hg)


HINT:

The vacuum pump assembly is listed as one of the 200000 km (124000 mile) maintenance parts. Make sure to disassemble and inspect it every 200000 km (124000 miles) and replace parts as necessary.



f.

Remove the vacuum gauge from the vacuum pump assembly.


g.

Connect the hose to the vacuum pump assembly with the clip.