Home › Brake › BRAKE (REAR) › REAR BRAKE(for TMT Made 4WD and Pre-Runner)
RM3250E _54 Brake _038047 BRAKE (REAR) _0189609 REAR BRAKE(for 4WD and Pre-Runner) A

BRAKE (REAR)  REAR BRAKE(for 4WD and Pre-Runner)  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 47644A 1.REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER LH

a.
C323378

Using needle-nose pliers, remove the rear brake automatic adjust lever tension spring and rear brake automatic adjust lever LH.


Hide 2.REMOVE BRAKE SHOES

a.
C323379

Using pliers, remove the 2 shoe hold down springs, 2 pins, front brake shoe and rear brake shoe.


b.
C323380

Push the front or rear side of the rear wheel brake cylinder assembly LH with the brake shoe. Then remove the side of the brake shoe opposite to the side of the cylinder being pushed. Finally, remove the remaining side of the brake shoe.

NOTICE:

Be careful not to damage the rear wheel cylinder dust boot.



c.
C323381

Move one of the shoes downward and remove the shoe tension spring.


d.
C323382

Remove the front brake shoe and rear brake shoe.


e.

Remove the parking brake shoe strut set LH and parking brake shoe return spring from the brake shoes.


f.

Remove the support clip from the parking brake shoe strut set LH and parking brake shoe return spring.


g.
C323383

Using needle-nose pliers, disconnect the No. 3 parking brake cable assembly from the rear brake parking brake shoe lever sub-assembly.


Hide 47602 3.REMOVE REAR BRAKE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY

a.
C326976C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the C-washer and rear brake parking brake shoe lever sub-assembly.


Hide 47570 4.REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY LH

a.
C323384

Using a union nut wrench, disconnect the brake line from the rear brake wheel cylinder assembly LH.


b.

Remove the 2 bolts and rear brake wheel cylinder assembly LH from the backing plate.


Hide 47548R 5.REMOVE REAR BRAKE DRUM BLEEDER PLUG CAP

Hide 47547R 6.REMOVE REAR BRAKE DRUM BLEEDER PLUG

a.

Remove the rear brake drum bleeder plug from the rear wheel brake cylinder assembly LH.


Hide 04474 7.REMOVE REAR WHEEL CYLINDER KIT

a.

Remove the 2 rear wheel cylinder dust boots from the rear wheel brake cylinder assembly LH.


b.

Remove the 2 rear wheel cylinder pistons.


c.

Remove the rear wheel cylinder cup from each wheel cylinder piston.


d.

Remove the rear brake wheel cylinder compression spring from the rear brake wheel cylinder assembly LH.